in short:
- Factory Reset
- exclude from Zwave-Network
- include into Zwave-Network
- Powernode Plug
- Powernode Port
- Room Selector
- Network/Sync Button
- Power button and activity indicator
exclude from existing zwave network
- unplug the power node
- push the network/sync button while plugging node into power outlet
- hold further for at least 5 seconds
- activity indicator led’s are rotating counter clockwise
- exclude device now from controller via device –> exclude from network (based on your controller e.g. fibaro hc 1/2/3, homee …)
Factory reset (if couldn’t be excluded from any existent zwave-network due to controller fault/damage):
- unplug the power node
- hold power button and plug node into a power outlet – hold button further for min. 5 seconds
- all leds of activity indicator flashing and appear off
- device is now ready to be included into a new zwave network
include into existing zwave network
- put your controller device into inclusion mode
- push the network/sync button on your power node
- the activity indicator should be rotating clockwise with 2 led
- the device should be included into zwave network shortly (look at your controller display / gui / website)
troubleshooting: following if any issues were reported by you or me 🙂
